Blog, Prints & Photography Lessons from Edinburgh and the Lothians

Posts tagged “filter

10 Stopper Comparison, Heliopan vs Hitech

With the recent purchase of a 2nd ten stop filter I finally had a chance to compare 2 of the them side by side. My original filter, a Heliopan ND3.0 has been well used and was a very good buy. However, the screw in can be cumbersome especially if you recompose for any reason.

The big problem with a screw in 10 stopper is that with it in place you can’t see anything at all through the viewfinder. This means you need to remove the filter to recompose and attach again for the shot. Either that or guess the composition, ramp up the ISO, take a test shot of a few seconds and adjust till you get the composition and then drop down to a low ISO and take the shot. Neither that handy if I’m honest.

Hence, the attraction of a slot in 10 stopper. In a perfect world I’d have bought a Lee Big Stopper, a proven product. Sadly, the Lee filter is almost impossible to get hold of right now thanks to supply issues at Lee and 2nd hand items are going for nearly double the price on ebay. Facing either nearly £200 for a Lee or a 6 month wait I opted for the new Hitech Pro Stopper.

Hitech claim this filter is made of a new IR resistant resin and they also claim to have fixed the light leak issues of the old filter by adding a 1.5mm gasket (for Lee holders, 3mm for Hitech holders). The filter comes in it’s own pouch and does seem pretty well made. Price is reasonable at £72 from TeamworkPhoto. TeamworkPhoto also supplied by Heliopan at a cost of £92 for the 77mm version.

So, how do they compare side by side?

10 stopper compare

This was a shot taken one after the other in dull conditions. Both shots were 90s exposures with a Hitech 150 0.9 GND in front of the 10 stopper. Same ISO, same lens, same f setting etc etc. The shot is a straight conversion of the RAW file to jpg for each with no PP applied.

As you can see, the Hitech does have a pronounced blue cast compared to the Heliopan which has a slightly warm cast but much better colour reproduction. Casts are not that hard to remove but obviously there is a lot less work to do with the Heliopan. The blue cast however, might be desirable in seascape type shots.

The Hitech also seems to let in slightly more light that the Heliopan, maybe not quite a full 10 stops? Other than that, all other areas of performance seem fairly equal.

So, it comes down a choice between the convenience of the slot in filter vs the colour reproduction of the screw in filter. Shooting for B&W, the slot in will be fine. Shooting for colour, I’d go with the fiddly screw in every time.

I’m going to keep the Hitech filter though, it’s got a place to be used where the screw in maybe isn’t convenient. The Hitech too unlike the other popular 10 stoppers in the market isn’t glass, it’s resin which should make it far less likely to end up in a million bits on some slippy rocks somewhere!


The never ending quest for decent photographic filters

About a year ago I made my first serious move into using filters in my photography. At that point the furthest I had gone down that route was a few cheap screw in circular polarisers, ND8’s and UV filters, which were fine for what they were but the more I read about filters and seen what other people were doing with them the more I wanted to stick a toe in this whole new world of photography.

Cost was an issue, isn’t it always, so I lowered expectations and bypassed the pro systems like Lee or Cokin Z and stated to look at a P series system, the 85mm slot in filter range. This seemed perfect as the filters were reasonably priced and there was a huge range to choose from. After some initial research I discounted Cokin’s range of ND filters as they got a terrible feedback online with dozens of complaints of purple colour casts on shots taken with the Cokin ND’s.

Eventually I settled on Formatt Filters Hitech range which seemed to be a decent alternative and bought a set of 0.3. 0.6 and 0.9 ND filters and a set of 0.3, 0.6 and 0.9 ND soft grad filters. Throw in a P series holder and a 77mm and 67mm adapter ring and I was no more than £75 out of pocket for a basic setup. I quickly also added a Kood 85mm slot in circular polariser to this line-up and for just under £100 I was ready to go.

The journey though, was a rough one. I learned a lot about filters and found that Hitech filters did indeed colour cast, especially with more than 2 stacked together. A 0.9 on its own was fine. A 0.9 soft grad on its own was fine. Stack the 2 and purple skies all round. At this point I nearly gave up, disheartened by the new purchases as they seemed to be a step back rather than the step forward I had hoped for.

In this situation, rather than throw in the towel it’s better to try and understand what is actually happening and how you can best avoid it. To this ends I started to see which conditions the filters worked best in and also figured out how to remove the worst of the cast in Photoshop so it was less of an issue. I soon stated using them all the time and was getting some reasonable results.

By this time I had added a cheap sunset grad, Kood red soft grad, Kood light tobacco soft grad and a Cokin 81A warm up filter to the collection and found that each of them worked best in certain situations. It took a lot of trial and error but once the understanding was there it made the frustration a lot less. Once you understand that in the middle of the day a red grad will give a shocking false image and used on a sunset it will work nicely you can really move on!

The next step was delving into long exposure photography. Initially I done this by stacking a screw in ND8, first then attaching the p series holder fitted with the Hitech 0.9 ND, 0.9 ND soft grad and 0.6 ND soft grad. Colour casting was horrific but I was able to get exposures up to long enough to streak clouds and flat out water, although the shots could only be used as mono conversions.

The solution to this was to invest in a proper 10 stop filter. Some research suggested that screw in types were best as they avoided light leak so I attempted to get a B+W ND110, which was the first time I came up against the difficulty in getting good filters. These were nowhere to be found, most places were quoting 6-12 week lead times which were no good to me, I wanted it now! Another quick Google and it seemed that the Heliopan ND3.0 was as good as the B+W and luckily, there was a stack of new 77mm versions on EBay at £95 a go. Cheaper than the B+W but even better, available now.

The Heliopan changed everything. Long exposures with no cast were now possible. Even stacking one 0.9 grad in some situations was possible but it still gave horrible casts from time to time. Not the Heliopan, it was perfect but the Hitech was no doubt the cause of the problem.

This got so frustrating I ended up buying the Lee filters foundation kit with intent to move to Lee filters, no matter what the cost. I got the holder at a decent price and it lay there unused as I had no 100mm filters for weeks on end. The problem this time was the lack of Lee filters anywhere. There are just none for sale, or at least for delivery this side of Christmas it seems. Some places are quoting 16 week + lead times for any Lee resin filters and as a result of this the 2nd hand market for them is nuts. 2nd hand Lee grads are going for silly money with this shortage and the “Big Stopper” even worse!

Eventually out of frustration I looked again at Hitech filters. Some recent blog comment seemed to suggest that the company had a new resin it was using and the results were near comparable with Lee filters for a fraction of the cost. This was based mainly around the Hitech equivalent to the Lee Big Stopper but there was also a new range of 100x150mm Hitech filters.

A quick search on eBay shows these filters going for around £40-£55 but in one of these rare moments where you get an actual bargain on eBay I found individual 0.6 and 0.9 soft grads for sale, made an offer and now own both for less than the cost of a single filter from some of the other sellers, both brand new and unmarked!

A quick test with these in conditions I would have normally expected to see colour cast produced no colour cast at all. Even a 30s exposure in tandem with the Heliopan 10 stopper produced no cast which is an encouraging start. Over the course of the next few weeks I’ll try these in a variety of ways and conditions and report back what the overall impression is.

If it’s good then an investment in a Hitech 0.9 reverse grad may well be in order and I’ll have to possibly consider the new version Hitech ND3.0 as well. The screw in Heliopan is a terrific filter but screw in and out in cumbersome if you need to recompose. A slot in option might well be handy but only if it performs as well.

I’m not discounting a switch to Lee in the future but for now while there is no availability there’s nothing to lose in trying the Hitechs, if nothing else it’s letting me use that nice new Lee filter holder at last!


Follow

Get every new post delivered to your Inbox.

Join 1,412 other followers